| Applicable vibration pickup |
|
electro-dynamic vibration velocity pickup
(Three types of pickup below are selectable by a trim switch.) |
|
|
Sensitivity;10mV/mm/sInput impedance;10kΩ |
|
|
Sensitivity;19.7mV/mm/sInput impedance;10kΩ |
|
|
Sensitivity;2.5mV/mm/sInput impedance;1MΩ |
| Vibration pickup input |
|
Channel A or Channel B (selectable) |
| Rotational signal input |
|
0～5V rise-up signal of 1 pulse per revolution
For indication of revolution and phase reference of the tracking filter |
| AC OUT |
|
Vibration waveform output ±2V/FS Output impedance 100Ω |
| Stroboscope output |
|
for the attached stroboscope (turned on and off by a switch) |
| Display |
|
Digital LED display and indicators |
| |
r.p.m. Indication / 500-10,000rpm Resolution 1rpm
Indication of FIL OUT vibration value / Overall vibration value
Indication of FIL IN vibration value / Filter pass value in Tracking or Man. Tune mode
Phase angle indication / 0 to 359 degrees angle between the rise of a revolution pulse and a positive peak of the vibration waveform of the component of revolution
LOCK indicator:Lights when the balancer is in synchronism with the revolution signal or the internal oscillator.
INPUT SEL indicator / Shows an input channel that is under measurement
Unit indicator:Lights to indicate an acceleration, velocity, or displacement |
|
| Analog meter |
|
0-1 scale over 0-3 scale |
|
|
Shows the filter pass value in the Tracking or Man.Tune mode |
|
|
Shows an overall vibration value |
| Printer |
|
A built-in thermal printer |
|
|
Prints out the result of current measurement at any timing |
|
|
Captures vibration waveforms, performs FFT on them,
and prints out the resulting graph and a list of up to five peaks. |
|
|
Prints out the result of measurement of a selected channel
under the specified conditions. |
| Range of vibration measuring frequency |
|
10Hz~200Hz(±0.5dB) |
| Full scale range (10 dB step) |
|
|
|
|
1, 3.16, 10, 31.6, 100 ×1/100mm(P-P)FS |
|
|
1, 3.16, 10, 31.6, 100 mm/s (Peak) Full scale |
|
|
1, 3.16, 10, 31.6 ,100 m/s2(Peak) Full scale |
Stroboscopic balancer function
(FILTER:MAN.TUNE) |
|
Flashes at a vibration phase filtered with a frequency of theinternal oscillator as the central frequency. (500-10,000rpm) |
| Automatic capture and print function |
|
Automatically captures vibration data according to OR of an r.p.m. change pitch and a time lapse pitch and prints out it together with time data. |
| Tracking filter function |
|
Automatic tuning with the signal from the revolution sensor by the tracking filter |
| Power supply |
|
AC100V±10V, Normally 1A or less, 2A fuse |
| Dimensions and weight |
|
(W)300×(H)123×(D)230mm,4.5kg |
